Resin Settings Finder
✦ Resin Advisor
Not sure which resin? Answer 3 quick questions.
Select your printer to begin
—
—
Normal Exposurei
Time each layer is exposed to UV. Too high = blurry detail. Too low = layer separation.
—
Bottom Exposurei
Extended UV time for the first few layers. Creates strong adhesion to the build plate.
—
Bottom Layersi
Number of layers using bottom exposure. Usually 5–8 layers.
—
Layer Heighti
Thickness of each printed layer. Thinner = more detail, slower print.
—
Transition Layersi
Layers that gradually shift from bottom to normal exposure. Reduces suction cup effect on FEP.
—
Suggested starting point
Rest / Delay Timei
Wait time after each lift before next exposure. Lets resin flow back, reduces FEP stress.
—
Suggested starting point
Note:
Quick fix guide
Soft / melted detail−0.1s
Support fail / thin parts break+0.1s
Print falls from plate+3–5s bottom
Layer separation+0.1s
Supports hard to remove−0.05s
Visible support bumpsTip 0.22 · D 0.12
Water washable soft / weak+0.1s
Clean support removal
Principle: Smaller + shallower supports remove easier. Best placement: hidden / underside surfaces only.
Clean
Tip 0.20–0.25
D 0.10–0.15
D 0.10–0.15
Painting / display
Balanced
Tip 0.25–0.30
D 0.18–0.20
D 0.18–0.20
General prints
Safe
Tip 0.30–0.35
D 0.25–0.30
D 0.25–0.30
Large / heavy / risky
Need more help?
Choose a Printer
Select your printer above
to load verified print settings.
to load verified print settings.